Grouts And Anchors

Product Details:

Lokfix is a polyster resin grout. Lokfix P is used in overhead or horizontalholes where bar / hole relationship conforms to Lokfix polyester resin grout S. The thixotropic nature of Lokfix polyester resin grout P reduces flow of grout out of the hole.

Product Details:

Lokfix E75 is a two-component Epoxy anchoring material, supplied in 3:1 ratio side-by-side cartridges with a static mixer nozzle. When applied it sets and cures to firmly secure a variety of steel fixings into concrete and solid masonry substrates.

Product Details:

Product Details:

It is a roller applied, liquid water-proofing membrane for direct use under thin and thick-bed installations of ceramic tile, stone and other finishes. It is recommended for residential and commercial floor and wall installations.

Product Details:

ArmGrout M-50 is recommended for precision grouting where it is essential to with stand static load and typical applications like base plates of turbine, Generators, compressors, boilers etc. it is basically a free flow non shrink high strength expansive, grout. It is based on port land cement with graded aggregated and additives which impart controlled expansion in the plastic state. The non shrink grout function is three folds, to fill the voids between the base plate and the concrete foundations completely and permanently without shrinkage or separating from either to transfer all loads from the base plate to the concrete foundation and to maintain precise alignment. It effectively transfers all operational loads to the foundation.

Product Details:

ArmGrout HF 66 is polyester based two component resin system specially made to give excellent anchorage. ArmGrout HF 66 can be used to an anchor size of 25mm. Diameter into concrete, rock, masonry or brick work where high speed of installation and early application of load is required.

Product Details:

Bostik Anchor Grout is polyester resin based grout material suitably blended with a hardening compound and fillers and supplied as a pre measured, two part, resin grout. After hardening , the grout has high mechanical properties. Bostik Anchor Grout is used where the difference between the hole diameter and bar diameter is ≤ 25mm.